Canon imageRUNNER ADVANCE C5500 Series, Service Manual, Page: 1100 / 1331

SORTER > ADJUST
STP-SPD 1 Adj dvry speed at staple mode: Fin-Y1
Detail To adjust the delivery speed to the stack tray at staple mode or staple-free binding mode.
As the value is changed by 1, the delivery speed changes by 10 mm/sec.
Use Case When the paper stacking at staple mode or staple-free binding mode is misalignment
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Caution - When the value is decreased, the productivity is decreased.
- When the buffer operation is performed, delivery speed does not change. (The buffer operation
is the operation to deliver the stacking paper on the processing tray.)
The ON/OFF of buffer operation is set by BUFF-SW.
Display/Adj/Set Range -5 to 5
Unit mm/s
Related Service Mode SORTER> OPTION> BUFF-SW
Amount of Change per
Unit
10
RBLT-PS2 1 Adj of Return Belt height: Fin-Y1
Detail To adjust the height of the Return Belt when aligning the paper on the processing tray.
As the value is changed by 1, the height of the return belt changes by angle of 0.1 degree.
+: Downward
-: Upward
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
Use Case When the misalignment of paper stack occurs during alignment operation on the processing tray.
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Caution The height of Return Belt during the paper alignment on the processing tray is the total of setting
values of RBLT-PRS and PBLT-PS2, so adjust again the setting value of RBLT-PS2 if necessary
when changing the setting value of RBLT-PRS.
After the setting value is changed, write the changed value in the service label.
Display/Adj/Set Range -30 to 30
Unit °
Related Service Mode SORTER>ADJUST>RBLT-PRS
Supplement/Memo Perform this adjustment after executing adjustment of RBLT-PRS.
Amount of Change per
Unit
0.1
FUNCTION
SORTER > FUNCTION
FN-SENS1 1 Adj Punch Horz Rgst Sensor: Fin-H1/Y1
Detail To automatically adjust the output of the Horizontal Registration Sensor 1 to 5 of the Puncher Unit
in sequence.
Horizontal Registration Sensor 1: A3/A4, 2: LDR/LTR, 3: B4/B5, 4: A4R/LTRR/LGL, 5: B5R
Use Case
- When installing/replacing the Puncher Unit
- When replacing the Horizontal Registration Sensor of the Puncher Unit
Adj/Set/Operate Method
Select the item, and then press OK key.
Caution
When the sheet of paper is on the sensor, the adjustment fails.
Display/Adj/Set Range During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
8. Service Mode
1086