Canon imageRUNNER ADVANCE C5500 Series, Service Manual, Page: 1103 / 1331

SORTER > FUNCTION
MTR-ON 1 Motor operation check: Fin-H1/Y1
Detail To start operation check of the motor specified by MTR-CHK.
After the motor operates for the specified period of time (10 to 30 seconds), it automatically stops.
Use Case - When checking whether there is any failure in the motor
- When checking the operation of the replaced motor
Adj/Set/Operate Method Select the item, and then press OK key.
Caution - When the job starts during the operation of the motor, the finisher sequence error jam occurs.
- When the error avoidance jam occurs during the operation of the motor, the jam becomes the
error immediately.
Display/Adj/Set Range During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
Related Service Mode SORTER> FUNCTION> MTR-CHK
SL-CHK 1 Specification of oprtn Solenoid (Fin-H1)
Detail To specify the Solenoid to operate.
Use Case
When replacing the Solenoid/checking the operation
Adj/Set/Operate Method
Enter the value, and then press OK key.
Display/Adj/Set Range
1: Paper trailing edge pushing guide solenoid
Default Value
1
Related Service Mode SORTER> FUNCTION> SL-ON
SL-ON 1 Operation check of solenoid: Fin-H1
Detail To start operation check for the Solenoid specified by SL-CHK.
After the solenoid operates for the specified period of time (10 to 30 seconds), it automatically
stops.
Use Case When replacing the Solenoid/checking the operation
Adj/Set/Operate Method Select the item, and then press OK key.
Display/Adj/Set Range During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
Related Service Mode SORTER> FUNCTION> SL-CHK
CNT-FCON 1 Parts Counter clear: Finisher: Fin-H1/Y1
Detail To clear the parts counter that the Finisher Controller PCB counts.
Use Case
When clearing the parts counter of the Finisher
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
FR-ST-RP 1 Ppr dust remov at stpl free stpl:All Fin
Detail To remove the paper dust from the staple-free binding unit, the staple-free binding operation
repeatedly is executed 30 times without paper.
When this mode is executed, the performance of the staple-free binding unit recovers.
Use Case When the performance of the staple-free binding unit deteriorates
Adj/Set/Operate Method Select the item, and then press OK key.
Caution Finisher-H1/Y1:
- The part counter value of the staple-free binding operation increases.
Finisher-Y1:
- When the job starts during the operation of this mode, the finisher sequence error jam occurs.
- When the error avoidance jam occurs during the operation of this mode, the jam becomes the
error immediately.
Display/Adj/Set Range During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
Related Service Mode COPIER> COUNTER> DRBL-2> FR-STPL
Supplement/Memo The removed paper dust accumulates on the lower frame under the paper path, so it does not
influence to the machine performance.
The part counter value of the staple free stapling operation is counted.
8. Service Mode
1089