Cabletron Systems CSMIM-T1, Administrator'S Manual

Page: 361 / 418

CSMIM/Micro-CS Management Application Guide 19-61
name_server_1
defines the type of name service used with the primary name server. This
parameter works only when you specify a host in
pref_name1_addr
.
name_server_2
defines the type of name service used with the secondary name server.
The Annex uses this service when the service specified in
name_server_1
is
not available. This parameter works only when you specify a host in
pref_name2_addr
.
nameserver_broadcast
defines whether the Annex broadcasts a name server request if the
preferred name servers do not respond.
need_dsr
allows an Annex to use the DSR (Data Set Ready) signal to determine
whether a device is attached to the corresponding asynchronous line. The
Annex will not allow connection to a slave line port and will not activate CLI
until the DSR signal is active. If DSR is deactivated, the connection to a
slave line is terminated and CLI is deactivated.
If you choose
disabled
, the DSR signal is not required to connect to a slave
line, and is not required to activate a CLI line. DSR is always considered
Type Annex
Values dns, ien_116, none
Default none
Lists Annex Only, Nameserver
Type Annex
Values dns, ien_116, none
Default none
Lists Annex Only, Nameserver
Type Annex
Values enabled or disabled
Default disabled
Lists Annex Only, Modem