VIBROTEST 60
Acquiring and displaying measurements
_________________________________________________________________________________
© VTEST60E July 2013 V4.46ff
C102 853.002
Page 67 of 168
Example 2:
Starting a new Listing memory.
•
Load a »Report« with
one
measurement from the PC-card.
•
Push the cursor button . The loaded measure-ment is
given the number „1„ in a Listing memory. The counter
number on the display shows the number „2„. The
VIBROTEST 60 is now ready to take the new measurement
number „2„.
•
Start the new measurement with softkey »START«.
•
Store the new measurement with cursor button . The
counter number is increased from „2„ to „3„.
Displaying measurements in the Listing memory:
After ending the measurement task (button »STOP«) the
respective measurements in the Listing memory can be
displayed using the cursor buttons , .
Deleting measurements in the Listing memory:
After ending the measurement task (button »STOP«) you may:
•
Delete single measurements in the Listing memory with the
softkey »DEL 3« (in this example measured value no. 3) or
•
Delete all measurements in the Listing memory with the
softkey »
«.
Note:
If you use the softkey »
« or you exit the operating mode
»Overall / BCU« (button »EXIT«) all measurements in the
Listing memory will be deleted. If however you want to use
these measurements for later evaluation, they must be stored
on the PC-card using the button »STORE«.
Storing Overall values to the PC-card
See section 8 „Storing measurements (Reports) on the
PC-card“.
