Brocade Communications Systems 53-1001763-02, Administrator'S Manual

Page: 321 / 586

Fabric OS Administrator’s Guide 281
53-1001763-02
Traffic Isolation Zoning over FC routers with Virtual Fabrics
12
Using D,I notation, the port numbers for the TI zones in the logical fabric and base fabric are as
follows:
Note that the base fabric zone contains a reference to port 1,3 even though the base switch with
domain 1 does not have a port 3 in the switch. This number refers to the port in the
chassis with
port index 3, which actually belongs to LS3 in FID 1.
Traffic Isolation Zoning over FC routers with Virtual Fabrics
This section describes how you can set up TI zones over FC routers in logical fabrics. Figure 47
shows two physical chassis configured into logical switches. The initiator in FID 1 communicates
with the target in FID 3 over the EX_Ports in the base switches.
FIGURE 47 Example configuration for TI zones over FC routers in logical fabrics
Figure 48 shows a logical representation of the configuration in Figure 47 . This SAN is similar to
that shown in Figure 40 on page 274 and you would set up the TI zones in the same way as
described in “Traffic Isolation Zoning over FC routers” on page 273.
Port members for the TI zone in logical fabric Port members for the TI zone in base fabric
8,8 F_Port
8,1 E_Port
3,3 E_Port
3,10 E_Port
5,16 E_Port
5,8 E_Port
9,5 E_Port
9,9 F_Port
1,3 E_Port for ISL in logical switch
1,10 E_Port for XISL
7,12 E_Port for XISL
7,14 E_Port for XISL
2,16 E_Port for XISL
2,8 E_Port for ISL in logical switch
= Dedicated Path
Base switch
Domain 1
LS3, FID1
Domain 3
Base switch
Domain 2
LS2, FID3
Domain 6
E
E
E EX
EX EX
E
F
EX
E
E
F
E E
= Ports in the TI zones
11
12
1
2
3
4
5
6
7
10
13
14
15
16