Black Box LGB6026A, Management Manual

Page: 1192 / 1289

– 1190 –
C
HAPTER
47 | IP Routing Commands
Open Shortest Path First (OSPFv3)
Console(config)#interface vlan 1
Console(config-if)#ipv6 router ospf area 0 tag 0 instance-id 0
Console(config-if)#
R
ELATED
C
OMMANDS
router ipv6 ospf (1178)
router-id (1181)
ipv6 router ospf tag area (1190)
ipv6 router ospf tag
area
This command binds an OSPF area to the selected interface and process.
Use the
no form to remove the specified area from an interface.
[ no ] ipv6 router ospf tag process-name area area-id
[ instance-id instance-id ]
area-id - Area to bind to the current Layer 3 interface. An OSPF
area identifies a group of routers that share common routing
information. The area ID can be in the form of an IPv4 address or
as a four octet unsigned integer ranging from 0-4294967295.
process-name - A process name used to distinguish between
multiple routing instances configured on the local router.
(Range: Alphanumeric string up to 16 characters)
instance-id - Identifies a specific OSPFv3 routing process on the
link-local network segment attached to this interface.
(Range: 0-255)
C
OMMAND
M
ODE
Interface Configuration (VLAN)
D
EFAULT
S
ETTING
No areas are defined.
C
OMMAND
U
SAGE
◆
An area ID uniquely defines an OSPF broadcast area. The area ID
0.0.0.0 indicates the OSPF backbone for an autonomous system. Each
router must be connected to the backbone via a direct connection or a
virtual link.
◆
Set the area ID to the same value for all routers on a network segment.
◆
The process-name is only used on the local router to distinguish
between different routing processes (and must be configured with the
router ipv6 ospf command before using it in this command.
◆
The instance-id is used on the link-local network segment to distinguish
between different routing processes running on the same link, and
allows routers participating in a common routing process to form
adjacencies and exchange routing information.
◆
The backbone (area 0.0.0.0) must be created before any other area.