Black Box LGB6026A, Management Manual

Page: 1005 / 1289

– 1003 –
C
HAPTER
41 | Multicast Filtering Commands
MLD (Layer 3)
D
EFAULT
S
ETTING
400 seconds
C
OMMAND
M
ODE
Interface Configuration (VLAN)
E
XAMPLE
The following example sets the interval for sending unsolicited IGMP
reports to 5 seconds.
Console(config)#interface vlan
Console(config-if)#ip igmp proxy unsolicited-report-interval 5
Console(config)#
MLD (L
AYER
3)
This section describes commands used to configure Layer 3 Multicast Listener
Discovery (MLD) on the switch
.
Table 130: MLD Commands (Layer 3)
Command Function Mode
ipv6 mld Enables MLD for the specified interface IC
ipv6 mld last-member-
query-response-interval
Configures the frequency at which to send query
IC
messages in response to receiving a leave message
ipv6 mld max-resp-
interval
Configures the maximum host response time IC
ipv6 mld query-interval Configures frequency for sending host query messages IC
ipv6 mld robustval Configures the expected packet loss IC
ipv6 mld static-group Statically binds multicast groups to a VLAN interface IC
ipv6 mld version Configures MLD version used on an interface IC
clear ipv6 mld group Deletes entries from the MLD cache PE
show ipv6 mld groups Displays information for MLD groups PE
show ip igmp interface Displays multicast information for aninterface PE
ipv6 mld
This command enables MLD on a VLAN interface. Use the no form of this
command to disable MLD on the selected interface.
S
YNTAX
[ no ] ipv6 mld
D
EFAULT
S
ETTING
Disabled