Black Box LGB6026A, Management Manual

Page: 1117 / 1289

– 1115 –
C
HAPTER
47 | IP Routing Commands
Global Routing Configuration
link-local-address % zone-id – a link-local address, including a
zone-id indicating the VLAN identifier after the % delimiter.
distance – An administrative distance indicating that this route can
be overridden by dynamic routing information if the distance of the
dynamic route is less than that configured for the static route. Note
that the default administrative distances used by the dynamic
unicast routing protocols is 110 for OSPF and 120 for RIP.
(Range: 1-255, Default: 1)
D
EFAULT
S
ETTING
No static routes are configured.
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
Up to 1K static routes can be configured.
◆
Up to eight equal-cost multipaths (ECMP) can be configured for static
routing using the
maximum-paths command.
◆
If an administrative distance is defined for a static route, and the same
destination can be reached through a dynamic route at a lower
administration distance, then the dynamic route will be used.
◆
The default distance of 1 will take precedence over any other type of
route, except for local routes.
◆
If both static and dynamic paths have the same lowest cost, the first
route stored in the routing table, either statically configured or
dynamically learned via a routing protocol, will be used.
◆
Static routes are included in RIP and OSPF updates periodically sent by
the router if this feature is enabled by the OSPFv3
redistribute
command (see page 1185 ).
E
XAMPLE
This example forwards all traffic for subnet 2001::/64 to the next hop
router 2001:DB8:2222:7272::254, using the default metric of 1.
Console(config)#ipv route 2001::/64 2001:DB8:2222:7272::254
Console(config)#
R
ELATED
C
OMMANDS
show ip route summary (1111)