Black Box LGB6026A, Management Manual

Page: 745 / 1289

– 743 –
C
HAPTER
29 | Authentication Commands
802.1X Port Authentication
◆
When this device is functioning as an edge switch but does not require
any attached clients to be authenticated, the
no dot1x eapol-pass-
through command can be used to discard unnecessary EAPOL traffic.
E
XAMPLE
This example instructs the switch to pass all EAPOL frame through to any
ports in STP forwarding state.
Console(config)#dot1x eapol-pass-through
Console(config)#
dot1x system-auth-
control
This command enables IEEE 802.1X port authentication globally on the
switch. Use the
no form to restore the default.
S
YNTAX
[ no ] dot1x system-auth-control
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
Console(config)#dot1x system-auth-control
Console(config)#
dot1x intrusion-
action
This command sets the port’s response to a failed authentication, either to
block all traffic, or to assign all traffic for the port to a guest VLAN. Use the
no form to reset the default.
S
YNTAX
dot1x intrusion-action { block-traffic | guest-vlan }
no dot1x intrusion-action
block-traffic - Blocks traffic on this port.
guest-vlan - Assigns the user to the Guest VLAN.
D
EFAULT
block-traffic
C
OMMAND
M
ODE
Interface Configuration