Black Box LGB6026A, Management Manual

Page: 1124 / 1289

– 1122 –
C
HAPTER
47 | IP Routing Commands
Routing Information Protocol (RIP)
C
OMMAND
M
ODE
Router Configuration
C
OMMAND
U
SAGE
◆
This command can be used to configure a static neighbor (specifically
for point-to-point links) with which this router will exchange routing
information, rather than relying on broadcast or multicast messages
generated by the RIP protocol.
◆
Use this command in conjunction with the passive-interface command
to control the routing updates sent to specific neighbors.
E
XAMPLE
Console(config-router)#neighbor 10.2.0.254
Console(config-router)#
R
ELATED
C
OMMANDS
passive-interface (1123)
network
This command specifies the network interfaces that will be included in the
RIP routing process. Use the
no form to remove an entry.
S
YNTAX
[ no ] network { ip-address netmask | vlan vlan-id }
ip-address – IP address of a network directly connected to this
router.
netmask - Network mask for the route. This mask identifies the
network address bits used for the associated routing entries.
vlan-id - VLAN ID. (Range: 1-4093)
D
EFAULT
S
ETTING
No networks are specified.
C
OMMAND
M
ODE
Router Configuration
C
OMMAND
U
SAGE
RIP only sends and receives updates on interfaces specified by this
command. If a network is not specified, the interfaces in that network will
not be advertised in any RIP updates.