Black Box LGB6026A, Management Manual

Page: 1006 / 1289

– 1004 –
C
HAPTER
41 | Multicast Filtering Commands
MLD (Layer 3)
C
OMMAND
M
ODE
Interface Configuration (VLAN)
C
OMMAND
U
SAGE
MLD (including query functions) can be enabled for specific VLAN interfaces
at Layer 3 through the
ipv6 mld command.
E
XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ipv6 mld
Console(config-if)#end
Console#show ipv6 mld interface
Vlan 1 : Up
MLD : Enabled
MLD Version : 2
MLD Proxy : Disabled
MLD Unsolicited-report-interval : 400 sec
Robustness variable
: 2
Query Interval : 125 sec
Query Max Response Time : 10 sec
Last Member Query Interval : 1 sec
Querier : ::
Joined Groups :
Static Groups :
Console#
ipv6 mld last-
member-query-
response-interval
This command configures the frequency at which to send MLD group-
specific or MLDv2 group-source-specific query messages in response to
receiving a group-specific or group-source-specific leave message from the
last known active host on the subnet. Use the
no form to restore the
default setting.
S
YNTAX
ipv6 mld last-member-query-response-interval seconds
no ipv6 mld last-member-query-response-interval
seconds - The frequency at which the switch sends group-specific or
group-source-specific queries upon receipt of a leave message.
(Range: 1-255 seconds)
D
EFAULT
S
ETTING
10 (1 second)
C
OMMAND
M
ODE
Interface Configuration (VLAN)
C
OMMAND
U
SAGE
When the switch receives an MLD or MLDv2 leave message from a host
that wants to leave a multicast group, source or channel, it sends a
number of group-specific or group-source-specific query messages at