Black Box LGB6026A, Management Manual

Page: 646 / 1289

– 644 –
C
HAPTER
25 | System Management Commands
Line
C
OMMAND
U
SAGE
The databits command can be used to mask the high bit on input from
devices that generate 7 data bits with parity. If parity is being generated,
specify 7 data bits per character. If no parity is required, specify 8 data bits
per character.
E
XAMPLE
To specify 7 data bits, enter this command:
Console(config-line)#databits 7
Console(config-line)#
R
ELATED
C
OMMANDS
parity (646)
exec-timeout
This command sets the interval that the system waits until user input is
detected. Use the
no form to restore the default.
S
YNTAX
exec-timeout [ seconds ]
no exec-timeout
seconds - Integer that specifies the timeout interval.
(Range: 0 - 65535 seconds; 0: no timeout)
D
EFAULT
S
ETTING
CLI: No timeout
Telnet: 10 minutes
C
OMMAND
M
ODE
Line Configuration
C
OMMAND
U
SAGE
◆
If user input is detected within the timeout interval, the session is kept
open; otherwise the session is terminated.
◆
This command applies to both the local console and Telnet connections.
◆
The timeout for Telnet cannot be disabled.
◆
Using the command without specifying a timeout restores the default
setting.
E
XAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#exec-timeout 120
Console(config-line)#