BENSHAW RediStart MX2 SEP, User Manual

Page: 45 / 130

4 - Keypad Operation
45
4.12 Alphanumeric Display
The remote LCD keypad and display uses a 32-character alphanumeric LCD display. All controller functions
can be accessed by the keypad. The keypad allows easy access to controller programming with parameter
descriptions on the LCD display.
4.12.1 Power Up Screen
On power up, the software part numbers are displayed for a few seconds. Pressing any key immediately
changes the display to the operate screen.
Software PN
810027-01-08
4.12.2 Operate Screen
The Operate Screen is the Main Screen. The Operate Screen is used to indicate the status of the controller: if it
is running, what state it is in, and display the values of Meter 1 and Meter 2, which are selectable.
The Operate Screen is divided into five sections:
• Sections A and B display status information
• Sections C and D display the meters selected by the Meter 1 and 2 parameters, see FUN 01–02
• Section S displays the source for the start command
Figure 17: Operate Screen
Table 12: Operate Screen Section A
Display Description
noL
L1, L2, L3 not present
Ready
Controller ready to run
Alarm
A fault condition is present. If it continues, a fault occurs
Run
Controller is running
Table 13: Operate Screen Section B
Display Description
Stopped
Controller is stopped and no Faults
Fault
Controller tripped on a Fault
Lockout
Controller is Locked Out due to an unusual condition being present
K
S T O P P E D V a = 0 V n o L I a = 0.0 A
Section A Section C Section S
Section B Section D