BENSHAW RediStart MX2 SEP, User Manual

Page: 39 / 130

4 - Keypad Operation
39
4.5 Messages Displayed
In addition to being able to view and change parameters, various special messages may be displayed during
different conditions. Here is a summary of the possible special messages.
The following sections provide more detail for some of the conditions that cause special messages to be
displayed.
LED Display
noL
No Line Voltage
rdY
Ready
run Controller active
Sync Motor running and synchronized
FF
Motor running, synchronized, with field forcing being applied
PO Motor pullout / pole slip detected.
inch
Inching field control mode active
dynb Dynamic braking active.
L CP
Low Control Power – A start is not allowed because the control power is low.
L Ot
Power Stack Over Temperature Lockout
LOC Lockout State
AbC
Phase order meter showing ABC phasing
CbA Phase order meter showing CBA phasing
SPH
Phase order meter showing single phase
P xx XX = parameter code
A xx
XX = alarm code. If the condition persists, a fault will occur
F xx
XX = fault code
b AL BIST mode, waiting for line voltage to be applied
b Fl
BIST mode, field supply active
b - BIST mode, BIST complete
dFLt
Default – Flashes when parameter defaults are loaded.
FLSH In Reflash mode, waiting for download
ProG
In Reflash mode, programming
rEAd
In Reflash mode, verifying
donE In Reflash mode, complete