BENSHAW RediStart MX2 SEP, User Manual

Page: 87 / 130

6 - Parameter Descriptions
87
FUN 15 / P59 Miscellaneous Commands
LCD / LED
Displays
FUN: Misc Command
15 None
Range LCD LED Description
None
0
No commands (Default)
Powered BIST 1 Built In Self Test with line voltage applied to the controller
Reset RT
2
Reset Run Time Meter
Reflash Mode 3 Activate Reflash Mode
Store Params
4
The current parameter values are stored in non-volatile memory
Load Params 5 All parameter are retrieved from non-volatile memory
Factory Rst
6
All parameters are restored to the factory defaults
Description The Miscellaneous Commands parameter is used to issue various commands to the MX
2
SEP controller.
The powered BIST command will put the controller into a powered BIST test. See section 8.7.1 on Page 107.
The Reset Run Time command resets the user run time meters back to zero (0).
The Reflash Mode command puts the MX
2
SEP into a reflash program memory mode. The reflash mode can
only be entered if the MX
2
SEP controller is idle. When the reflash mode is entered, the MX
2
SEP waits to be
programmed. The onboard LED display shows “FLSH”. The remote display is disabled after entering reflash
mode. The MX
2
SEP does not operate normally until reflash mode is exited. Reflash mode may be exited by
cycling control power.
The Store Parameters command allows the user to copy the parameters into non-volatile memory as a backup.
If changes are being made, store the old set of parameters before any changes are made. If the new settings
do not work, the old parameter values can be loaded back into memory.
The Load Parameters command loads the stored parameters into active memory.
The Factory Reset command restores all parameters to the factory defaults. These can be found in chapter 5.
O