RediStart MX
2
- SEP Synchronous Controller User Manual
108
8.7.2
BIST Programming / Test Instructions
Step 1
LCD Display
LED Display
Access FUN 15 then press [ENTER].
Access P59 then press [ENTER].
Increment up to “Powered BIST”
Press [UP] button to #6
then press [ENTER].
then press [ENTER].
Powered BIST test will commence
.
Powered BIST test will commence.
FUN: Misc Command
15 Powered BIST
Step 2 - Apply Line
The MX2 SEP will indicate that line power must be applied if line power is not present.
LCD Display
(BIST Mode)
LED Display
Apply line
to begin BIST
Step 3
-
DC Field Test
The MX
2
SEP will provide the programmed field current to the motor. Measure the DC current with an ammeter
to verify the proper current is being applied. This level will be maintained for 60 seconds before moving to the
next step, or the start button can be pressed at any time to move on.
LCD Display
(BIST Mode)
LED Display
BIST I = x.xA
Field Test
Step 4
LCD Display
(BIST Mode)
LED Display
BIST Mode
Tests completed
The controller will reset back to normal operation once the BIST is complete.
Pressing [ENTER] on the keypad at any time will abort the BIST test.
NOTE:
The powered BIST tests will verify that the input phase order is correct. If the measured phase
order is not the same as the “Phase Order” (FUN 05 / P34) parameter a phase order fault will
occur.
O
BA1
BF1
B--
Summary of Contents for RediStart MX2 SEP
