BENSHAW RediStart MX2 SEP, User Manual

Page: 80 / 130

RediStart MX
2
- SEP Synchronous Controller User Manual
80
I/O 14 / P58 Keypad Stop Disable
LCD / LED
Displays
I/O: Keypad Stop
14 Enabled
Range LCD LED Description
Disabled
OFF
Keypad Stop does not stop the controller
Enabled
On
Keypad Stop does stop the controller (Default)
Description If “Disabled”
When this parameter is set to “Disabled”, the keypad [STOP] button is de-activated; this should be done with
caution, as the [STOP] button will not stop the controller.
If “Enabled”
When this parameter is set to “Enabled”, the keypad [STOP] button is enabled and trips the controller on a
keypad stop fault regardless of the selected control source (QST 04 / P37
or QST 05 / P38) selected as
(terminal or serial).
See Also • Local Source (QST 04 / P37) parameter on Page 61.
• Remote Source (QST 05 / P38) parameter on Page 61.
I/O 15 / P57 Auto Start Selection
LCD / LED
Displays
I/O: Auto Start
15 Disabled
Range LCD LED Description
Disabled
0
When disabled, the Start input must always transition from low to high for a
start to occur.
(Default)
Power
1
When set to Power, a start will occur if the Start input is high while control power
is applied.
Fault
2
When set to Fault, a start will occur if the Start input is high when a fault is reset.
Power, Fault
3
When set to Power and Fualt, a start will occur if the Start input is high while
control power is applied, and a start will occur if the Start input is high when a fault
is reset.
Description The Auto Start parameter determines whether or not a transition from low to high is required on the Start input
for a start to occur after either a power up or a fault reset.
On
0