Baroness LM2700, Service Manual

Page: 119 / 325

1 Wheel motor
2 Bolt
3 Spring washer
4 Nut
5 Kingpin
Remove the O-ring and adapter from the
wheel motor.
Caution
Make sure that no dirt or dust enters the
wheel motor or adapter.
1
3
2
3
2
otacki-009
Removal of Rear Wheel Motor_003
1 Wheel motor
2 Adapter
3 O-ring
Installation of Rear Wheel Motor
Caution
After the installation, check if there is no oil
leakage in each part.
Caution
See "Tightening torques" (Page 3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
6.
Important
Make sure of the installing locations of the
hydraulic hoses and do not install them at the
wrong locations.
Important
When you re-use the wheel motor or adapter,
completely remove the seal tape which
remains on the thread portion.
For installation, reverse the removing
procedure.
Control Valve
Removal of Control Valve
Remove the right tank cover. (See
"Removal of Right Tank Cover" (Page
7-39) .)
Important
Before removing the hydraulic hoses and
pipes, check their installation positions.
Remove the meter panel. (See "Removal of
Meter Panel" (Page 7-40) .)
Remove the hydraulic hose and pipe.
1
3
2
d3mo2k-003
Removal of Control Valve_001
1 Control Valve
2 Hydraulic hose
3 Hydraulic pipe
1.
2.
3.
Hy
draulic system
LM2700
Hydraulic system
Page 5-65 Removal and installation of each section