Baroness LM2700, Service Manual

Page: 205 / 325

Danger Danger
A clearance that is too small may result in
heat generation or fire.
Loosen the adjustment nut to adjust the
clearance to about 0.2 mm (0.0079 in), and
then check that the disc rotates freely.
Tighten the lock nut, and then fully tighten it
while holding the adjustment nut in place.
With the brake pedal released, obtain a
play of 1.0 mm (0.039 in) at the connection
of the pedal and inner wire.
1 mm (0.039 in)
1
2
3
4
ebex3a-002
Adjustment of Brake_004
1 Inner wire
2 Adjustment bolt
3 Brake wire (outer)
4 Joint part
Use a wrench to loosen the adjustment bolt
and tighten it after making the adjustment.
Start the engine and drive to check the
following.
Make sure that heat is not generated in
the brake area.
Make sure that the left and right brakes
are equally effective.
3.
4.
5.
6.
7.
･
･
Danger Danger
It would be extremely dangerous and may
result in an unexpected accident if the left
and right brakas are not equally effective.
If the left and right brakes are not equally
effective, make fine adjustments with the
adjustment bolt on the brake wire.
1
nfzln9-004
Adjustment of Brake_005
1 Adjustment bolt (on brake disc side)
Break-in of Brakes
If the brake shoes or brake pads are worn,
replace them with new ones.
Immediately after replacement, drive to break
in the brakes if the effectiveness of the brakes
is low.
While driving, lightly operate the brakes to
break in the contact areas.
8.
￭
Main
bo
dy
LM2700
Main body
Page 7-11 Adjustment