Baroness LM2700, Service Manual

Page: 243 / 325

Wear of the brake pad may cause increased
amount of pedal depression, which results in
contact of the pedal with the floor or uneven
braking. Inspect the brake.
Clearance between disc and pad shall be
adjusted as even for the left and right
brakes. (See "RT mechanical brake
manual" (Page 10-12) .)
2
1
6dn2w2-002
Inspection of Brake_001
1 Disc
2 Brake pad
Brake pad wears out gradually as the brake
is used just like an eraser.
Check the remaining amount at the
inspection. Replace if it is too small.
The brake pad wear limit is 3.0 mm (0.12
in). (See "RT mechanical brake manual"
(Page 10-12) .)
Disassembling and Assembling the Brake
Caution
Many portions of the brake are exposed
outside due to structural reason.
Any oil or grease attached on and around the
brake main body may cause negative impact
to braking performance, therefore they need
to be cleaned using a brush, cloth, etc.
Remove the brake pad.
（
(See "RT
mechanical brake manual" (Page 10-12) .)
Disassemble and assemble the brake.
（
(See "RT mechanical brake manual"
(Page 10-12) .)
1.
2.
1.
2.
Inspection of Parking Brake
Danger Danger
Make sure that the brake wire is not cracked
or damaged.
Danger Danger
Make sure that the brake is effective on
slopes and that it is not applied any longer
when you release it.
Adjust the parking brake system whenever
there is any abnormality.
Follow the steps below to check that the
parking brake is effective.
Depress the brake pedal on a slope with
15-degree gradient.
Pull the parking brake lever and apply the
parking brake.
2
1
r6e5n8-001
Inspection of Parking Brake 001
1 Brake pedal
2 Parking brake lever
Apply the parking brake on a slope with 15-
degree gradient and make sure that the
machine is completely stopped.
If it does not stop completely, make
necessary adjustment. (See "Adjustment of
Brake" (Page 7-10) .)
1.
[1]
[2]
2.
Main
bo
dy
LM2700
Main body
Page 7-49 Inspection and repair of each section