Baroness LM2700, Service Manual

Page: 113 / 325

Installation of Gear Motors
Caution
After the installation, check if there is no oil
leakage in each part.
Caution
See the list in "Tightening torques" (Page
3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Make sure of the installing locations of the
hydraulic hoses and do not install them at the
wrong locations.
Insert the gear motor into the mower unit,
and fix it at two fixing positions with bolts,
spring washers, and washers.
Install the hydraulic hoses.
Raise/lower cylinder
Removal of Up/down Cylinder
Mower Units #1/#2/#3
Caution
Exercise care in handling the hydraulic
cylinder since it is heavy.
Start the engine, and then lower all mower
units.
Stop the engine, and then remove the key.
1.
2.
￭
1.
2.
Important
Before removing the hydraulic hose, check its
installation position.
Follow the steps below to remove the up/
down cylinder.
Remove the hydraulic hoses from the
up/down cylinder.
Remove the two cotter pins, slotted nuts
and spring washers.
Remove the up/down cylinder.
3
4
5
2
1
4
3
5
owl71y-003
Mower Units #1/#2/#3_001
1 Hydraulic hose
2 Up/down cylinder
3 Cotter pin
4 Slotted nut
5 Spring washer
3.
[1]
[2]
[3]
Hy
draulic system
LM2700
Hydraulic system
Page 5-59 Removal and installation of each section