Baroness LM2700, Service Manual

Page: 162 / 325

Adjust the heights of mower units #4 and
#5 to 390.0 mm (15.35 in) by hand.
3 3
2 1
3ykki3-002
Traveling/Working Circuit_002
1 Mower unit #4
2 Mower unit #5
3 Setting value [390.0 mm (15.35 in)]
Follow the steps below to adjust the
proximity sensor.
Loosen the two bolts so that the switch
mounting bracket can be moved.
Gradually move the proximity sensor on
the switch mounting bracket.
Tighten the two bolts in the position
where the proximity sensor which has
been turned off is illuminated.
1
2
4
5
3
3ykki3-003
Traveling/Working Circuit_003
1 Proximity sensor
2 Bolt
3 Proximity sensor adjustment hole
4 Switch mounting bracket
5 Cam
6.
7.
[1]
[2]
Push in the knob of the electro-magnetic
valve of mower units #4 and #5.
Turn the knob 180 degrees in an
anticlockwise fashion to set it back to the
original position. (The knob is shrunken)
Adjust the proximity sensor for mower unit
#5 in the same manner.
Anti-Falling Circuit
Remove the right side cover.
Start the engine, and then lower all mower
units.
Move the mower unit up/down lever to the
neutral position.
Warning
Be sure to stop the engine before adjusting
the proximity sensor.
Stop the engine.
Turn the main switch on.
8.
9.
1.
2.
3.
4.
5.
LM2700
Electrical system
Page 6-14 Adjustment