Baroness LM2700, Service Manual

Page: 69 / 325

Caution
Be careful to never give the locknut more
than one turns. If you give it more than one
turn, the thread fit between the other side port
and locknut becomes loose, which reduces
the thread strength.
If the washer goes too deeply into the other
side port, the washer gets deformed, which
leads to oil leakage.
Rough installation makes the main body and
nut overloaded, which leads to deformation.
Be sure to observe the installation procedure.
To fit, screw the main body by hand till the
washer face touches lightly, and turn from
that position in the loosening direction to
the setting position.
After fitting the opposite screw, tighten the
lock nut while holding the main body with
a spanner etc. to ensure that the setting
position does not change.
Taper Pipe (PT) Thread Joint (Sealing Tape
Method)
Make sure that the taper thread portion is
not damaged or contaminated with foreign
objects.
1
14d3iz-001
Taper Pipe (PT) Thread Joint (Sealing Tape Method)_001
1 Taper (PT) thread portion
3.
4.
1.
Important
If a used taper pipe (PT) thread joint retains
the residue of old sealing tape, using it again
for assembly may cause machine problems
or oil leakage.
Important
If you remove a taper thread joint, remove the
sealing tape residue from the joint and
connecting portion, so that the tape residue
will not enter the hydraulic system.
1
14d3iz-002
Taper Pipe (PT) Thread Joint (Sealing Tape Method)_002
1 Taper (PT) thread connecting portion
Before connecting the joint, wind sealing
tape on the taper thread portion. (See "How
to Use the Sealing Tape" (Page 5-16) .)
1
14d3iz-003
Taper Pipe (PT) Thread Joint (Sealing Tape Method)_003
1 Taper (PT) thread portion
2.
Hy
draulic system
LM2700
Hydraulic system
Page 5-15 General instructions