Baroness LM2700, Service Manual

Page: 257 / 325

Adjustment
Adjustment of Blade Engagement
Check to see the clearance between the reel
cutter (cutting cylinder) and the bed knife
(bottom blade), and adjust them, if necessary.
For the method of adjustment, refer to the
Owner
’
s Operating Manual.
Cutting Height Adjustment
Adjust the front and rear rollers so as to obtain
desired cutting height.
See Owner
’
s Operating Manual for method of
adjustment.
Adjustment of Cutter Spring
Due to working conditions, the gap between the
reel cutter (cutting cylinder) and the bed knife
(bottom blade) may fluctuate. If necessary,
check the clearance and make adjustment.
Adjust the length of A to 27.0 mm (1.06 in) with
the pipe with cutter adjusting screw.
1 A
gu4891-001
Adjustment of Cutter Spring_001
1 Pipe with cutter screw
A 27.0 mm (1.06 in)
Adjustment of Mower Stabilizer
Important
Once the cutting height adjustment has been
completed, adjust the mower stabilizer.
The mower stabilizer shifts the weight of the
cutting unit from the front roller to the rear roller.
(It stabilizes the mower unit and prevents
undulating finish (phenomenon called
Marcelling).)
When using this machine on a markedly uneven
place, shorten (compress) the spring.
Lower all mower units on a level place.
Apply the parking brake, stop the engine.
Loosen the lock nut.
Tighten the nut to adjust (compress) the
length of the spring to 140.0 mm (5.51 in).
Tighten the lock nut.
A
1 2 3
3ttzyg-001
Adjustment of Mower Stabilizer_001
1 Lock nut
2 Nut
3 Spring
A 140.0 mm (5.51 in)
Adjustment of Groomer Height
Note:
Depending on the specifications, this function
may not be available.
Adjust the groomer height at your will.
For the method of adjustment, refer to the
Owner
’
s Operating Manual.
1.
2.
3.
4.
5.
Op
erating
Machin
e an
d
Mower Units
LM2700
Operating Machine and Mower Units
Page 8-9 Adjustment