ScreenPRO-II Controller • User’s Guide
229
6. Operations
Working with Layers
tçêâáåÖ=ïáíÜ=mfmë=áå=péäáí=jçÇÉ
In
Split Mode
,
the mixer’s two layers operate
independently
.
Use the following steps to work with PIPs in
Split Mode
.
1.
In the
Layer Control Section
, ensure that the
Split
button is
On
.
2.
Press the desired layer button (
A
or
B
). Please note:
~
The layer button blinks to indicate that it is active for modification.
~
In the
Source Selection Bus
, the source assigned to the layer blinks.
~
On Preview, the raster box for the selected layer blinks (even if it is
hidden under another layer).
3.
In the
Layer Functions Section
, ensure that the
PIP
button is lit and the
PIP
Adjustment Menu
is visible. If the menu is not visible, press
PIP
.
4.
On the
Source Selection Bus
, press the button for the desired (new) source.
The button blinks to indicate that it is selected, and the source appears within the
PIP on Preview.
5.
Adjust the PIP’s size, position, border, shadow, source image, cropping and
special effects. Refer to the “
Modifying PIPs
" section on page 230 for details.
6.
Prior to the transition, you can set up an additional layer if desired in
Split Mode
:
~
To set up an additional “
Split Mode
” PIP in Preview, repeat the
procedure from step 2.
~
To set up a Key in Preview, refer to the “
Working with Keys in Split
Mode
" section on page 231.
7.
Press
CUT
or
AUTO TRANS
to transition the look to program. Refer to the
“
Working with Transitions
" section on page 241 for details.
8.
Repeat the procedure from step
1
for the next transition.
tçêâáåÖ=ïáíÜ=mfmë=áå=jáñ=jçÇÉ
In
Mix Mode
, the mixer’s layers are ganged together. Both PIPs can be perfectly co-
located on screen (
Mix Source
mode), or both can operate independently (
Swap
mode),
but only one PIP can be on Program at a time.
Use the following steps to work with PIPs in
Mix Mode
.
1.
In the
Layer Control Section
, ensure that the
Split
button is
Off
.
2.
Press the desired layer button (
A
or
B
). Please note:
~
The layer button blinks to indicate that it is active for modification.
~
In the
Source Selection Bus
, the source assigned to the layer blinks.
Note
Even though this mode allows you to display two PIPs (or
Keys) on air, it is more restrictive. Once both layers are on
Program, you must transition them off Program, make
changes — and then transition them back on.
Layer
A
Note
Even if the layer is on Program, the
PIP Adjustment Menu
appears, but parameters can not be adjusted.
Summary of Contents for ScreenPRO-II
