ScreenPRO-II Controller • User’s Guide
207
5. System Setup
Input Setup
e.
Scroll to the
Gamma
line and set the input gamma.
f.
Scroll to the
Input Sync Type
line and set the type of sync used by the
selected source.
g.
Scroll to the
Pulldown Compensation
line and enable (or disable) the
mode.
h.
Scroll to the
Sync Slice <mv>
line and adjust as required.
i.
Scroll to the
Sharpness
line and set the input’s sharpness.
j.
Press
{
SAVE
}
to save the input configuration.
8.
Perform additional setups on the
Aspect Ratio Menu
—
if required
:
a.
Press
{
AR
}
to display the
Aspect Ration Menu
.
b.
Adjust the
Mode
and
Ratio
as required.
c.
Press
{
SAVE
}
to save the input configuration.
d.
Press
{
BACK
}
to return to the
Input Menu
.
9.
Perform additional setups on the
Sizing Menu
—
if required
:
a.
Press
{
SIZING
}
to display the
Sizing Menu
.
b.
If
1:1 Sampling
was selected:
•
Scroll to the
Clock Phase
line and set the system’s A/D
converter.
•
Scroll to the
H Total
line and set the total pixel count per line.
•
Scroll to the
H Active
line and set the width of the active area.
•
Scroll to the
H Position
line and set the start of the active
area’s horizontal offset from H sync.
•
Scroll to the
V Active
line and set the number of vertical lines in
the image.
•
Scroll to the
V Position
line and set the start of the active area’s
vertical offset from V sync.
•
Press
{
SAVE
}
to save the input configuration.
•
Press
{
BACK
}
to return to the
Input Menu
.
c.
If
Oversample
was selected:
•
Scroll to the
Right Edge
line and adjust as required.
•
Scroll to the
Left Edge
line and adjust as required.
•
Scroll to the
Top Edge
line and adjust as required.
•
Scroll to the
Bottom Edge
line and adjust as required.
•
Press {
SAVE
} to save the input configuration.
•
Press {
BACK
} to return to the
Input Menu
.
10.
Perform additional setups on the
Color Balance Menu
—
if required
:
a.
Press
{
COLOR BALANCE
}
to display the
Color Balance Menu
.
b.
If an
RGB
source was selected:
•
Scroll to the
Red Contrast
line and adjust as required.
•
Scroll to the
Red Brightness
line and adjust as required.
•
Scroll to the
Green Contrast
line and adjust as required.
•
Scroll to the
Green Brightness
line and adjust as required.
•
Scroll to the
Blue Contrast
line and adjust as required.
•
Scroll to the
Blue Brightness
line and adjust as required.
•
Press {
SAVE
} to save the input configuration.
Summary of Contents for ScreenPRO-II
