186
ScreenPRO-II Controller • User’s Guide
5. System Setup
ID Setup and Remote Enable
fa=pÉíìé=~åÇ=oÉãçíÉ=bå~ÄäÉ=
ScreenPRO-II Controller system setup:
Step 1
.
In this procedure, you will set up individual ScreenPRO-II IDs and enable remote control.
Each ScreenPRO-II in your system must have a unique ID.
Use the following steps to set up ScreenPRO-II IDs and remote control:
1.
On an individual ScreenPRO-II system, press {
REMOTE CONTROL
}
on the
Home Menu
to access the
Remote Control Menu
.
2.
Scroll to the
Unit ID
line, and select a unique ID for the ScreenPRO-II chassis.
The ID range is
1
to
32
.
3.
Scroll to the
Remote Control/DHCP
line, and enable remote control and DHCP.
4.
Repeat steps
1
through
3
for all other ScreenPRO-II units in your system.
1
Note
When remote control is on, the {
HOME
} buttons disappears,
the ScreenPRO-II’s front panel is disabled, and the unit’s IP
address is dynamically assigned. All control now originates
from the ScreenPRO-II Controller’s console.
Summary of Contents for ScreenPRO-II
