ScreenPRO-II Controller • User’s Guide
239
6. Operations
Using Move
mêçÖê~ã=~=jçîÉ=çå=mêçÖê~ã
This mode enables you to program a move with the layer on both Program and Preview —
after the layer has transitioned to Program.
Use the following steps to program a move on Program:
1.
In the
Layer Control Section
, select the layer (on Program) that you want to
move (
LAYER A
or
LAYER B
). The button blinks to indicate that it is active for
modification. Note that its current position is the move’s "starting" location.
2.
In the
Layer Functions Section
, press
Move Setup
. The button blinks to
indicate that you are now actively defining the properties of the move.
3.
Size and position the PIP or Key to its “ending” location. Note that on Preview,
only the raster box moves
.
4.
Press
Move Setup
again to complete the programming. The button remains lit,
and the raster box returns to its starting location on Preview.
5.
To set up an additional move on the other layer (provided that you are in
Split
Layer
mode), repeat the procedure from step 1.
To pend and trigger the move, refer to the "
Pending and Triggering Moves
" section.
mÉåÇáåÖ=~åÇ=qêáÖÖÉêáåÖ=jçîÉë
For each layer on which you have programmed an associated move, you can “pend” and
"trigger" the move in one of two ways — on
Preview
or on
Program
.
•
Pend on Preview
•
Pend on Program
mÉåÇ=çå=mêÉîáÉï
This "pend" method enables you to move the PIP or Key
automatically
on the next
transition.
Use the following steps to pend a move on Preview:
1.
With the move properly programmed, ensure that the layer containing a move is
selected and blinking.
2.
To pend the move, press
Move
in the
Layer Functions Section
. The button
lights to indicate the pending move. On Preview, the raster box blinks at the
"destination" location —
not
the PIP or Key’s current location.
3.
Perform a
CUT
or
AUTO TRANS
. The transition takes the Preview image to air,
and the move begins immediately on both Program and Preview.
4.
To move the layer back to keyframe 1, press
Move
. The button lights and on
Preview, the raster box blinks at the "starting" location.
5.
Perform a
CUT
or
AUTO TRANS
. In this "ping-pong" manner, you can continue
to transit back and forth between keyframes 1 and 2.
Summary of Contents for ScreenPRO-II
