78
ScreenPRO-II Controller • User’s Guide
3. Hardware Installation
BlendPRO-II Widescreen Lock Connections
b.
Connect the first ScreenPRO-II’s
GENLOCK LOOP
connector to the
GENLOCK IN
connector on the ScreenPRO-II unit with the
next highest
numbered ID
.
c.
(If your system includes three ScreenPRO-IIs) — Connect the second
ScreenPRO-II’s
GENLOCK LOOP
connector to the
GENLOCK IN
connector on the ScreenPRO-II with the
next highest numbered ID
.
d.
(If your system includes four ScreenPRO-IIs) — Connect the third
ScreenPRO-II’s
GENLOCK LOOP
connector to the
GENLOCK IN
connector on the ScreenPRO-II unit with the
highest numbered ID
.
e.
Set the
Termination Switch
for all ScreenPRO-IIs in your system:
•
For all ScreenPRO-IIs
except the last one
in the chain, ensure
that the ScreenPRO-II is un-terminated (
HI-Z
). Refer to the
“
ScreenPRO-II Genlock Termination
” section on page 76 for
details.
•
On the
last unit
in the chain (only), ensure that the
ScreenPRO-II is terminated (
75-OHM
).
Summary of Contents for ScreenPRO-II
