Barco ScreenPRO-II, User Manual

Page: 185 / 292

ScreenPRO-II Controller • User’s Guide 185
5. System Setup
System Setup Sequence
póëíÉã=pÉíìé=pÉèìÉåÅÉ
This section provides a top level view of the entire ScreenPRO-II Controller setup
procedure, plus links to each individual procedure.
„
Preliminary steps:
1. “ ID Setup and Remote Enable ,” page 186.
2. “ System Power Up ,” page 187.
3. “ Return to Factory Default ,” page 189.
„
Next, set up all menus under the MISC heading:
4. “ Touch Screen Calibration ,” page 189.
5. “ Programming EDID ,” page 190.
6. “ Restore from Flash Memory Card ,” page 191.
„
Next, set up all menus under the System heading:
7. “ Standard Destination Setup ,” page 192.
8. “ Router Setup ,” page 193.
9. “ AUX Destination Setup ,” page 195.
10. “ Input Patching ,” page 198.
„
Next, set up all menus under the Output heading:
11. “ Output Format Setup ,” page 199.
12. “ Sync Setup ,” page 200.
13. “ Genlock Setup ,” page 201.
14. “ Projector Setup ,” page 202.
„
Set up all background inputs and primary sources:
15. “ Background Setup ,” page 205.
16. “ Input Setup ,” page 206.
17. “ DSK Setup Procedure ,” page 211.
18. “ LOGO Setup Procedure ,” page 212.
„
To complete your setup:
19. “ Saving the Setup ,” page 213.
20. “ Backup to Flash Memory Card ,” page 213.
All of the above procedures are covered in the following sections.
Important For the optimum ScreenPRO-II Controller system setup, it is
recommended that you follow all procedures in the order
outlined below.