12 LED Indicator Troubleshooting
In normal operation, the Power LED is steady green, and the Pass/Fail is green or red depending on the triggered inspection. The Ether-
net I/O LED will be lit or off depeding on connection status.
-
1
Power LED
Green: Power
Red: Error
2
Pass/Fail LED
Green: Pass
Red: Fail
3
Ethernet I/O LED
Green: Connected
No Light: Disconnected
The iVu also indicates abnormal conditions as described below.
12.1 Errors
Problem Indicator
Solution
The Pass/Fail LED is blinking green a number of
times, separated by an LED red blink, and the sen-
sor repeats this pattern over and over. This indi-
cates that no inspections are occurring.
Reboot the sensor.
The Power LED is lit steady red. These type of er-
rors are reported in the System log and appear
highlighted in red.
Do the following:
1. Look in the System Log to see the error.
2. Clear the LED; that is, go to the Main Menu > Logs > System Logs and
press the Clear System Error button at the bottom of the screen (a sensor
reboot is not required).
3. If the error occurs again, you can try rebooting the sensor to see if that fix-
es the problem. If the problem persists, contact Banner customer support.
12.2 Warnings
iVu Plus BCR User's Manual
152
www.bannerengineering.com - tel: 763-544-3164
Rev. B
Summary of Contents for iVu Plus BCR
Page 1: ...iVu Plus BCR User s Manual Rev B 1 25 2012...
Page 56: ...iVu Plus BCR User s Manual 56 www bannerengineering com tel 763 544 3164 Rev B...
Page 64: ...iVu Plus BCR User s Manual 64 www bannerengineering com tel 763 544 3164 Rev B...
Page 104: ...iVu Plus BCR User s Manual 104 www bannerengineering com tel 763 544 3164 Rev B...
