Bandai Namco RAZING STORM, Operation Manual

Page: 55 / 136

7. OPERATION
51
(b) GUN INITIALIZE 1P-2P (Gun Assy aim setting 1P-2P)
This screen is used to adjust the aim of the Gun Assys.
Select “GUN INITIALIZE 1P” or “GUN INITIALIZE 2P” in the I/O Test screen and press
the Enter switch.
The Gun Initialize screen (1) appears.
The Gun Initialize screen (1) enables the confirmation of the aim of the Gun Assy.
When the Gun Assy is pointed toward the screen, the aim of the Gun Assy is
indicated by a crosshair. Make sure that the crosshair appears at a location where
the gun is aimed.(By following the procedure described on the next page, make
sure that the aim is accurate in the entire screen from edge to edge.)
When the Gun Assy is pointed outside the screen, a message “+ OUT OF
” is shown at location [a].
Press the Enter switch to return to the I/O Test screen.

If the "+OUT OF " message continues to appear even if the Gun Assy is
pointed toward the screen, the problem may be caused by one or more of the
following reasons.

There are powerful light sources nearby.

There are some objects in the surrounding area that reflect LED light.

The Gun Assy is positioned too close to or too far from the screen.

The Gun Assy is pointed at the screen from a very large angle.
If this happens, change the machine installation location or aim from the correct
location, and readjust the aim of the Gun Assy.
GUN INITIALIZE 1P
PUSH SERVICE SW :ADJUST GUN SIGHT
ENTER SW :EXIT
+OUT OF
AIM AT SCREEN
TO CHECK GUN ACCURACY
(Gun crosshair)
Indicates the aim of the gun.
Indicates "GUN INITIALIZE 1P"
or "GUN INITIALIZE 2P."
[a] Out-of-screen indication
GUN INITIALIZE screen (1)