Avaya Media Gateway G250, Administration Manual

Page: 530 / 840

Configuring the router
530 Administration for the Avaya G250 and Avaya G350 Media Gateways
Configuring ICMP errors
You can control whether the router sends Internet Control Message Protocol (ICMP) error
messages. The router sends an ICMP error message to the source of a packet if the router
rejects the packet. Use the following commands to configure ICMP errors:
●
Enter
ip icmp-errors
to set ICMP error messages to on. Use the
no
form of this
command to set ICMP error messages to off.
●
Enter
show ip icmp
to display the status (enabled or disabled) of ICMP error messages.
Summary of ICMP errors commands
For more information about these commands, see Avaya G250 and Avaya G350 CLI
Reference , 03-300437.
Configuring RIP
The Routing Information Protocol (RIP) enables routers to compute the path that an IP packet
should follow. Routers exchange routing information using RIP to determine routes that other
routers are connected to. OSPF is a newer protocol that serves a similar purpose. For more
information about OSPF, see
Configuring OSPF on page 536.
You can configure route redistribution between OSPF, RIP, and static routes. With route
redistribution, you can configure the G250/G350 to redistribute routes learned from one protocol
into the domain of the other routing protocol. For more information, see
Route redistribution on
page 541.
Table 132: ICMP errors CLI commands
Command Description
ip icmp-errors
Set ICMP error messages to ON or OFF
show ip icmp
Display the status (enabled or disabled) of ICMP error messages