Avaya Media Gateway G250, Administration Manual

Page: 186 / 840

Configuring Standard Local Survivability (SLS)
186 Administration for the Avaya G250 and Avaya G350 Media Gateways
4. If the BRI link is employed with ISDN, and the glare-handling convention is specified as
peerMaster
or
peerSlave
for the ISDN link (set in Step 3), enter
set side side
to
specify the glare mode: either
a
or
b
.
5. If the BRI link is employed with ISDN, enter
set country-protocol country-code
to specify the ISDN Layer 3 country protocol type, where
country-code
is any the
values listed in Table 50 .
6. If the BRI link is employed with ISDN, enter
set bearer-capability bearer
to set
the Information Transfer Rate field of the Bearer Capability IE, where
bearer
is one of
the following values:
●
3khz
. 3.1 kHz audio encoding
● speech
. Speech encoding
7. Enter
set interface-companding type
to set the far-end companding method,
where
type
is one of the following values:
●
alaw
. A-law companding
● ulaw
. U-law companding
8. If the BRI link is employed with ISDN, enter
set tei-assignment tei
to select the
method by which the Layer 2 (LAPD) protocol obtains its Terminal Endpoint Identification
(TEI) address.
tei
is one of the following values:
● auto
. TEI is assigned by the network provider
●
zero
. TEI is fixed administratively
9. Enter
set directory-number-a number
to assign a directory number to the B1
channel of the BRI link.
number
is the provisioned number received from the network
provider. The
number
value must be identical to the number the network provider has
assigned to the circuit.
10. Enter
set directory-number-b number
to assign a directory number to the B2
channel of the BRI link.
number
is the provisioned number received from the network
provider. The
number
value must be identical to the number the network provider has
assigned to the circuit.
11. Enter
set spid-a number
to assign an SPID to the B1 channel of the BRI link.
12. Enter
set spid-b number
to assign an SPID to the B2 channel of the BRI link.
Note:
Note:
All BRI links must have SPIDs properly configured for the link to function. SPIDs
are received from the network service provider.
13. If the BRI link is employed with ISDN, enter
set-endpoint-init {yes | no}
to
determine whether or not the far-end supports endpoint initialization.
14. If the BRI link is employed with ISDN, enter
set layer1-stable {yes | no}
to determine whether or not to keep the physical layer active (stable) between calls. Some
European countries require that the physical layer is deactivated when there is no active
call.