Avaya Media Gateway G250, Administration Manual

Page: 482 / 840

Configuring monitoring applications
482 Administration for the Avaya G250 and Avaya G350 Media Gateways
Note:
Note:
If you enter
set crosstalk-destination none
, this indicates that the
crosstalk port will not attempt to make a call toward any destination but will expect
an incoming call. Remember to start the call before launching the test.
●
Use the
set crosstalk-responder
command to specify the responder port for
the crosstalk port.
Displaying and clearing profiles
●
In the
analog-test-profile
context, use the
show
command to display the test
profile.
●
In the
analog-test
context, use the
show profile
command to display a particular
profile or all profiles.
●
In the
analog-test
context, use the
clear profile
command to delete a particular
test profile or all profiles.
Launching and cancelling a test
Once you created a test profile, you can launch it when desired. However, due to memory
constraints on the analog media modules, only one test can be run at a time.
Note:
Note:
A test will fail if the port specified for the test is in use for a call, unless you
specified
set destination none
for this test profile.
1. Enter
analog-test
to enter the
analog-test
context.
2. Use the
launch
command to launch a specific test. The port specified in the test profile
must be busied out from Communication Manager before the test is launched.
Note:
Note:
As soon as
launch
is issued, the results of previous measurements on the port
are cleared.
You can use the
cancel
command to abort an analog test that is currently running.
Displaying test results
●
In the
analog-test
context, use the
show result
command to display the result of the
latest measurements performed for a particular profile.