Avaya Media Gateway G250, Administration Manual

Page: 55 / 840

Managing login permissions
Issue 5 June 2008 55
full path and
ip
is the IP address of the host. The gateway prompts you for a
username and password after you enter the command.
●
To download an authentication file from a remote SCP server:
copy scp auth-file
filename ip
, where
filename
is the name of the authentication file, including the
full path and
ip
is the IP address of the host. The gateway prompts you for a
username and password after you enter the command.
●
To download an authentication file from a remote TFTP server:
copy tftp
auth-file filename ip
, where
filename
is the name of the authentication file,
including the full path and
ip
is the IP address of the host. The gateway prompts you
for a username and password after you enter the command.
The authentication file is downloaded. You can view the download status using
show
download auth-file status
.
Note:
Note:
By default, Avaya Services login access is enabled as soon as the authentication
file is downloaded to the gateway. If Avaya Services login access was blocked
using
no login authentication services-logins
, you can reactivate is
using
login authentication services-logins
.
3. For connection to Avaya Services via modem dial-up, enable the RASaccess operation
mode for modem operation, using
ppp authentication ras
. The gateway must also
be configured for remote modem access and enabled, as described in Installing and
Upgrading the Avaya G250 Media Gateway , 03-300434 or Installing and Upgrading the
Avaya G350 Media Gateway , 03-300394.
4. For connection to Avaya Services via embedded VPN service, set up the VPN service for
Services to connect.
Replacing the ASG authentication file
In case of any problems with the ASG authentication file, you can download a newer
authentication file from the Authentication File System (AFS). You cannot install an
authentication file with a different authentication file ID to that of the authentication file currently
installed in the gateway.
Note:
Note:
If there is a need to install an authentication file with a different ID, you must first
delete the current authentication file using the command
erase auth-file
.
This command requires Supervisor level access and can only be used when
directly connecting to the Console or Services port. If you do delete the
authentication file and replace it with an authentication file with a new ID, the
authentication file label on the gateway chassis must also be replaced.