Avaya Media Gateway G250, Administration Manual

Page: 170 / 840

Configuring Standard Local Survivability (SLS)
170 Administration for the Avaya G250 and Avaya G350 Media Gateways
b. At the SAT, enter
display media gateway number
, where
number
is the gateway
number you obtained in Step a. This provides you with the location field value.
●
If the gateway has an administered location, at the SAT, enter
display
locations number
, where
number
is the administered location number. If there
is an ARS entry for the given location, you must use this value exclusively in the
SLS data set.
●
If there is no administered location, at the SAT, enter
display
feature-access-codes
and gather the FAC information listed in Table 43 .
Collecting System parameters data
1. At the SAT, enter
list media-gateway
to display a list of administered gateways.
2. Look for one of the following supported gateways in the Type field:
●
G250/G250-BRI/G250-DCP/G250-DS1
●
G350
3. Once you have determined the media gateway of interest, note its IP-Network-Region.
4. At the SAT, enter
display ip-network-region n
, where
n
is the gateway’s
administered IP-Network-Region.
Read the Codec-set field value from the IP Network Region form.
Table 43: Feature Access Codes to assemble for SLS
Page Field Name Notes
1 Contact Closure Open Code Used to open a contact closure relay
1 Contact Closure Close Code Used to close a contact closure relay
1 Contact Closure Pulse Code Used to pulse a contact closure relay
1 Auto Route Selection
(ARS) Access Code1 Specifies the first access code for ARS table
routing
1 Auto Route Selection
(ARS) Access Code2 Specifies the second access code for ARS table
routing
1-16 ARS FAC This is used instead of the Features form ARS
FAC entry if the “Loc No.” that correlates to the
gateway has an entry in this form, which
overrides the general ARS FAC(s)
1 CAS Remote Hold/ Answer
Hold-Unhold Access Code Specifies the dial access code to provision a
hold bridge on the call involving this station user.
Successive access to this dial code causes the
feature to toggle between the Hold and the
Unhold states.