Avaya Media Gateway G250, Administration Manual

Page: 394 / 840

Configuring advanced switching
394 Administration for the Avaya G250 and Avaya G350 Media Gateways
-
auto
. Attmepts to automatically detect the port’s connection type
For example, the following command specifies that ports 3 to 5 on module 6 are treated as
if they were connected point-to-point:
●
All ports . Enter
show port point-to-point status
, followed by the module and
port number, to display the point-to-point status of the specified point-to-point status of all
ports
Spanning tree CLI commands
Use the following commands to configure spanning tree. For more information about these
commands, see
Avaya G250 and Avaya G350 CLI Reference , 03-300437.
●
Use the
set port spantree
command to enable or disable the spanning tree mode for
specific switch ports.
●
Use the
set port spantree cost
command to set the spanning tree cost of a port.
This value defines which port will be allowed to forward traffic if two ports with different
costs cause a loop.
●
Use the
set port spantree force-protocol-migration
command to force a port
to send a rapid spanning tree hello packet (Bridge Protocol Data Unit).
●
Use the
set port spantree priority
command to set the spanning tree priority
level of a port. This value defines the priority of a port to be blocked in case two ports with
the same cost cause a loop.
●
Use the
set spantree default-path-cost
command to set the version of the
spanning tree default path cost used by this bridge.
●
Use the
set spantree enable/disable
command to enable or disable the spanning
tree algorithm.
●
Use the
set spantree forward-delay
command to specify the time used when
transferring the state of a port to the forwarding state.
●
Use the
set spantree hello-time
command to specify the time interval between the
generation of configuration BPDUs by the root.
●
Use the
set spantree max-age
command to specify the time to keep an information
message before it is discarded.
●
Use the
set spantree priority
command to set the bridge priority for STP.
●
Use the
set spantree tx-hold-count
command to set the value in packets used by
the spanning tree in order to limit the maximum number of BPDUs transmitted during a
hello-time period.
G350-001(super)# set port point-to-point admin status 6/3-5 force-true