Avaya IP500, Installation Manual

Page: 224 / 442

Installing IP500/IP500 V2 Page 224
15-601042 Issue 28c (19 August 2013) IP Office 9.0
10.3.4 BRI Combination Card
This card is used to add a combination of ports to an IP500 V2 control unit. Not supported by IP500 control units.
·
Supports
·
10 voice compression channels. Codec support is G.711, G729a
and G.723 with 64ms echo cancellation. G.722 is supported by IP
Office Release 8.0 and higher.
·
6 Digital Station ports for digital stations (except 3800, 4100,
4400, 7400, M and T-Series).
·
2 Analog Extension ports.
·
2 BRI Trunk ports (4 BRI channels).
·
10 voice compression channels. Codec support is G.711, G729a
and G.723 with 64ms echo cancellation. G.722 is supported by IP
Office Release 8.0 and higher.
· IP500 Control Unit:
·
IP500 V2 Control Unit:
·
Maximum per Control Unit: 2 combination cards of any type.
·
IP Office Basic Edition - Norstar Mode and IP Office Basic Edition
systems are limited to a maximum of 12 BRI channels using BRI
Combination and or BRI trunk daughter cards.
·
IP500 Trunk Card Support: 1. The trunk daughter card is pre-
installed and cannot be replaced with another card type.
Port Type Ports Features
Digit Station 1 to 6 Provides DS ports for digital stations (except 4100, 4400, 7400, M and T-Series).
LEDs
·
Green Flashing = Phone detected.
·
Green On = Phone active.
·
LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
Analog
Extension 7 to 8
·
Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20.
·
REN 2 (1 for external bell device).
·
Off-Hook current: 25mA
·
Ring Voltage: 40V.
·
Intended for connection to two-wire analog phones, the ports do not include a ringing
capacitor. For connection to 4-wire analog phones, connection should be via a master
socket with ringing capacitors.
·
No status LEDs are used for analog phone extensions.
BRI Trunk 9 to 10 · Each trunk port supports 2B+D channels.
· ETSI or AusTS013 basic rate protocol set through the IP Office configuration.
LEDs
·
Off = No trunk present.
·
Green on = Trunk present.
·
Green flashing = Trunk in use.
·
LED 9 is also used for daughter card status.
·
Red On = Error
·
Red Slow Flash = Initializing.
·
Red Flash every 5 seconds = Card okay.
·
Red Fast Flash = System shutdown.
Not Used 11 to 12 –
Name Description SAP Code
IPO IP500 V2 COMB CARD BRI IPO IP500 V2 COMBINATION CARD BRI 700476021
48
393 48