DCU
X
DCU + Event
X
X
X
RP
X
RP + Event
X
X
X
DCU + RP
X
X
DCU + RP + Event
X
X
X
X
Silent Event
DCU + Silent Event
X
RP + Silent Event
X
DCU + RP + Silent Event
X
X
Sea Trial Only
1
Select
Not in use
if the channel shall be disabled.
Select
Event
if the channel shall make any form of event. An event can be a warning, an
alarm, a load reduction or an engine shutdown.
Select
Silent Event
for an active channel, but no panel alarms. The event will be available
on communication only.
Select
DCU
and/or
RP
if the channel is to be displayed on a page.
The
Sea Trial Only
option is used to tag a channel for use in Sea Trial Mode only. This is
only applicable for a DCU that will provide data logging during a sea trial. Choosing this
option makes the channel active for viewing and data logging only when Sea Trial Mode is
active on the DCU.
Normally, and in most cases, the selection should be “DCU + RP + Event”, as
highlighted
in the table above. This makes sure the channel is displayed in the
DCU and in the RP, if – or when – the RP is installed.
1
Can be displayed when Sea Trial mode is active.
Page 18 (99)
