3.2.4 Save File as
This saves the current configuration of the DCU into a file. The default file extension is .cfg.
3.2.5 Save CANopen EDS-file
DCU 410E/408E only.
This saves the CANopen I/O electrical datasheet to a file on your PC.
3.2.6 Upload to DCU
Uploaded files are files transferred to the DCU.
The built-in firmware can be updated whenever there is a new firmware available.
New configuration files can be added to the DCU panel.
3.2.6.1 Firmware Update
Select the new DCU panel firmware to upload. The file name shall be
dcu410_<release>.tar.gz
.
The latest firmware release can be obtained from the Auto-Maskin web site.
Before upgrading the DCU it is recommended to take a backup of the current
configuration file, see “Save File as” chapter.
When upgrading a DCU to a new firmware it is recommended to also upgrade any
connected RPs to the latest available firmware as well.
If upgrading an RP it is similarly recommended to upgrade related DCUs.
3.2.6.2 Wallpaper
Select a picture file for the DCU. The file must be of type .png. Only one user wallpaper may
be uploaded. Uploading a new file will remove the old one.
3.2.6.3 Configuration File Upload
Select a user configuration file for the DCU. The file must be of type
<file_name>.cfg
.
When uploaded, the file is stored in the DCU, and is later available for use from the User
Uploaded files section.
3.3 I/O Configuration
Described in a separate chapter.
3.4 User Interface
Described in a separate chapter.
3.5 Start/Stop/Prelube
Described in a separate chapter.
Page 14 (99)
