78
© 2019, ATEÏS, member of PAX ProAV Group
1. Select the BGM source:
Press [SELECT] button to select the BGM source. The LED will light up in blue and indicate
that the BGM source that is selected.
2. Select the zones:
Press the zone button on [Zone Selector], and the BGM will be routed to the selected zones
on main controller and/or secondary units. The blue LED will light up if the zone is selected.
3. Start the routing by pressing the [ROUTE] button.
During the BGM routing, the [Zone Select] button(s) can be dynamically added in/removed
from the routing.
Cancel a BGM source to a zone
1. To cancel the routing for specific zones, press its zone selection button, and its corresponded
blue LED will light off.
2. Press [SELECT] button and make sure the BGM Source button lights off.
3. Press the [ROUTE] button again to cancel the routing.
Zone attenuators (volume knobs)
When using a BGM source (CD/AUX/USB etc.) to paging to zones, and the Evacuation option
on this source is disable, then users can change the volume of corresponding zones to the
desired attenuation level from the front panel of controller. The attenuators offer 6 attenuation
positions: 0, -3, -6, -9, -12, -15 dB.
4.6
Messages and microphone calls
Choose to play the four types of messages or do a zone call with the fireman mic on main
controller.
: Press it to play a EVAC message broadcasting.
: Press it to play the alert message to selected or pre-defined zones.
: Press it to play the testing alert message.
: Press the fireman mic to start the zone call to selected or pre-defined zones.
RESET: Press it to reset the emergency state. The evac message playing will be canceled,
and the red evacuation button will light off.
