Allen-Bradley 1440-SDM02-01RA, User Manual, Page: 93 / 168

Rockwell Automation Publication 1440-UM001D-EN-P - September 2016 93
Configure the XM-124 Standard Dynamic Measurement Module Chapter 2
I/O Data Tab
If a controller reads the poll output table of the module, then consideration
must be given to the content and organization of the displayed table before
configuring the module. The module configuration must support (produce)
the measurements defined in this table. Knowing what must be produced is
critical to properly configuring the module.
Figure 39 - 1 Main Editor View, I/O Data Tab
Change of State (COS)
The editor displays the structure of the COS table if the COS size or COS
output fields are clicked but the COS assembly is fixed and cannot be changed.
Poll Output
The output table defines the structure of the table output when polled by a
scanner. The size and contents of the poll output can be modified in either
Defined or Custom Assembly.
Status Shows the status of the trend data. Possible status values:
• Not collected - No trend data is collected.
• Collecting - A trigger has occurred and data is
being collected.
• Collected - A trend has been saved to the buffer
and is available to view and upload.
View Trend Data Displays a plot of the collected trend data.
Reset Trigger Resets the trigger if Latch enabled is selected. This reset enables the
module to overwrite the previous trend data when the machine speed
crosses into the speed range.
Table 19 - SU/CD Trend Parameters (Continued)
Parameter Name Description Values/Comments