Allen-Bradley 1440-SDM02-01RA, User Manual, Page: 25 / 168

Rockwell Automation Publication 1440-UM001D-EN-P - September 2016 25
Install the XM-124 Standard Dynamic Measurement Module Chapter 1
Mount the Terminal Base Unit on a DIN Rail
Use these steps to mount the terminal base unit on a DIN rail
(Allen-Bradley catalog no. 199-DR1 or 199-DR4).
1. Position the terminal base on the 35 x 7.5 mm DIN rail (A).
2. Slide the terminal base unit over leaving room for the side
connector (B).
3. Rotate the terminal base onto the DIN rail with the top of the rail
hooked under the lip on the rear of the terminal base.
IMPORTANT XM-124 module certifications are valid only when used with the 1440-TB-A/C
revision of the terminal base.
Position terminal base at a slight angle and hook over the top of the DIN rail.