Allen-Bradley 1440-SDM02-01RA, User Manual, Page: 54 / 168

54 Rockwell Automation Publication 1440-UM001D-EN-P - September 2016
Chapter 1 Install the XM-124 Standard Dynamic Measurement Module
Repeat the above steps to install another module in its terminal base.
Set the Module DIP Switch Under the slide at the top of the module is a 10 position DIP switch that is
used for setting the modules DeviceNet behavior, node address, and
communication rate. The switches are number from left to right and applied as
shown in
Figure 34 and in Table 5 .
Figure 33 - XM-124 Module DIP Switch Bank
Table 5 - DIP Switch Functions and Defaults
Down Position = 0
DIP Switch Enable/Disable
Normal Mode (on)/
Legacy Mode (off)
Mode Selection
Baud Rate Selection
When Switch 1 Is Off
Network Address
Selection When Switch
1 Is Off
Up Position = 1
Switch Purpose Function Out-of-box
Default Value Out-of-box
Switch Setting
1 DIP Switch disable Determines whether DIP Switches 3…10 are enabled. When this switch is in
the off position, DIP Switches 3…10 set the module’s node address and
communication rate. When the switch is on, the device ignores DIP Switches
3…10 and uses the network address and communication rate programmed in
nonvolatile storage. Switches enabled Off
2 Network mode Sets the DeviceNet behavior of the module to either Normal mode (ODVA
compliant) or Legacy mode, which is consistent with earlier XM module
versions. Normal (fully
compliant) On
3, 4 Data rate When switch #1 is off (0), it sets the DeviceNet communication rate. 125 Kbps Both off
5…10 Node address When switch #1 is off (0), it sets the DeviceNet node address. 63 All on
IMPORTANT Install the overlay slide label to help protect serial connector and
electronics when not adjusting the switch.