Clicking on 'ok' auto aligns the error detector.
The device can now be tested without clock loss.
N O T E
When SSC is enabled the measurement does not use SJ. The maximum available
jitter amplitude is reduced for the jitter tolerance measurement.
Running the Test
Once you have specified the
Standard
,
Frequency
, and
BER
, press the
Start
button to run the test.
The bar in the lower right-hand corner of the screen shows the progress.
You can also abort the test at any time by pressing the
Abort
button.
When the measurement is either completed or aborted, you can obtain
a list of measured points by clicking the following tab which appears
once the measurement is stopped.
Clicking on the above tab you get the list of measured points.
Jitter Tolerance Tests
7
Agilent J-BERT N4903 High-Performance Serial BERT
365
Summary of Contents for J-BERT N4903
