AGCO LELY RPC 130 F, Original Operator'S Manual

Page: 116 / 168

After 500 bales after the first use
Position in
figure Machine part Lubrication Note
16
Only machines with cutting device
XtraCut 17 and XtraCut 25:
grease knife lever.
(A)
500 bales after first use, then once
per season.
After each 500 bales (or daily)
Position in
figure Machine part Lubrication Note
Power Take-Off shaft. (A) Not shown.
17 Chain lubrication system. (B) On the right side of the machine.
6 Locking hook. (A) On the two sides of the machine.
18 Roller on locking device. (A) On the two sides of the machine.
14 Pick-up guide wheels. (A) On the two sides of the machine.
10 Lubricant metering device (roller
lubrication and rotor lubrication).
(A) On the two sides of the machine
(RPC 160 V).
10 Automatic Lubrication (roller
lubrication and rotor lubrication.
(A) On right side of machine (RPC 130
F).
19 Tailgate roller (at the lower edge of
the tailgate).
(A) On the two sides of the machine,
open the tailgate and make sure that
it does not move.
22 Grease nipple on the linkage point
of the ring frame.
(A) On the two sides of the machine.
23 Two grease nipples on the cylinder
linkage point of the ring frame.
(A) Two on both sides.
24 Two grease nipples on the brake
lever of the ring brake.
(A) On the right side of the machine.
24 Grease nipple of the ring tensioner. (A) On the left side of the machine.
25 Four grease nipples on the linkage
point of the film knife.
(A) Four on both sides.
4
4. Maintenance and Lubrication
116 Baler Wrapper Combination
4900.LE.EN01