AGCO LELY RPC 130 F, Original Operator'S Manual

Page: 62 / 168

Calibration of the Bale Shape
Do this procedure if the shape of the bale on the
left and right side changes in dimension too much.
Before you start the calibration, you must measure
how much the change is.
In the calibration screen, push the arrow button
on the line “Bale shape”.
• Push the button Calibration and follow the
instructions on the screen
• When the automatic calibration is done and the
shape of the bale is not correct during baling,
you can use the buttons or to set an
offset on the left and right side (only when bale
shape fine tune set to on)
• Push to go back to the page Calibration or
to go to the Home page.
GUID-652640CA-5712-4AF5-9ABA-3E169B2B087D-high.jpg [High]
Fig. 22
Calibrate the Wrapper Parts
Calibrate all parts of the wrapper on this screen:
• When first used
• At the start of the season
• When a different tractor is connected to the
machine.
Calibration procedure:
• Go to the calibration page and set the first line
“Bale transfer”
• Open the tailgate (possible in calibration menu,
follow instructions on the screen)
• Push the button
• Follow the instructions on the screen and push
the button to confirm
• Go to the subsequent line
• Do steps 2 - 4 again until all calibrations are
done
• Close the tailgate (possible in calibration menu,
follow instructions on the screen).
GUID-F4D3BB62-1D83-4155-B67B-0CD50191CE3E-high.jpg [High]
Fig. 23
2. Introduction
62 Baler Wrapper Combination
4900.LE.EN01