AGCO LELY RPC 130 F, Original Operator'S Manual

Page: 63 / 168

Diagnostic
On the diagnostics page it is possible to make a
selection of more than one page to show more
data during troubleshooting.
Push the button to show the data.
• “Inputs”: Shows the input signal. The button
shows the screen with input signals of the
wrapper
• “Outputs”: Shows the output signal. The
button shows the screen with output
signals of the wrapper
• “Error history”: Shows the error messages that
occurred and the number of times they
occurred.
Use the buttons up or down to make a
message selection and push to show
detailed error message data.
• “System information”: Shows the software
version, VT software version, the model, serial
number and the total number of bales and
hours
• “Manual trigger cycles”: Shows three cycles.
GUID-A5288EB8-F651-486F-A250-F18BF01DA4E6-high.jpg [High]
Fig. 24
Advanced user interface
Push to change the info boxes.
To set the units to inch or cm use the arrow
buttons up or down .
To make a language selection use the arrow
buttons up or down .
The selections save when you leave the page.
GUID-07D4759B-BCAE-4F5A-9FB7-5B4AD4EA4C93-high.jpg [High]
Fig. 25
2. Introduction
Baler Wrapper Combination 63
4900.LE.EN01