Advanced Instruments 4C3, User Manual

Page: 42 / 139

Direct Selection : For direct selection, press START at “Select Setup
Item” . The display will change to “Setup Menu #: 0” . At “Setup
Menu #: 0” , enter the number of the desired setup item (from the list
below) on the keypad and press ENTER. The display will change to the
selected menu item.
Sequential Selection: For sequential selection, repeatedly press the >
button to step the display forward or < to step the display backward
through the setup menu list. The displayed parameter list is cyclic;
pressing > at the last item cycles the display to item 0. Continue press-
ing > or < until the desired menu item
is displayed.
Note that while direct, numerical
selection is only available at
“Select
Setup Item”
,
>
or
<
stepping is
available from any menu position.
When the desired menu item is dis-
played, press the START button to
select the item, display the current
setting and enable changing the set-
ting.
The current setting is indicated either
by the symbol
“*”
or a numeric value
and may be changed by pressing
>
or
<
(or using the item-specific instruc-
tions below).
Press ENTER to store a new setting
(or STOP to restore the original set-
ting). The display will revert to the
title of the parameter selected. Then
you may press START to display
the new setting,
>
or
<
to step to the
next SETUP item, STOP to exit the
SETUP menu, or TEST to change to
the TEST menu.
20
The Advanced
®
Model 4C3 User’s Guide
Setup Mode Options
0. Select Setup Item
1. Set Block Bin #
2. Set Sample Bin #
3. Select Batch
4. Select Barcode
5. Set Stir Amplitude
6. Set Date/Time
7. Select Beeper
8. Set Serial Rate
9. Select Data Capture
10. Select Xon/Xoff
11. Select Plateau Mode
12. Set % DFB
13. Select Display mH/mC
14. Serial Number
15. Product/Test
16. Reservoir Status
17. Assistance
18. Select Language
Table 5: Setup Menu Options